🎯 Red LED Bullseye Clearance/Side Marker Light - Blazer C539R Review

Works well and easy to install BUT there is no seal on back wall. My setup was on and RV where water ingress must be avoided. The components inside the unit are waterproof, but nothing on the back prevents water from entering the motorhome. I wrapped the wires with butyl tape and wrapped the silicone ball on the outside.

I purchased the amber and red LED position lights to replace the OEM on my van. It's not 10 LEDs as advertised on Revain. But they are bright, brighter than my 2 standard OEM bulbs and easy to install. Overall I would buy them again but am disappointed as I needed the brightness of 10 LEDs and had to settle for 2 LEDs which are brighter than the OEMs I replaced.

False advertising! There are only 2 LEDs, not 10 diodes as they claim. This light can't even be compared to the incandescent version of the same application. I bought them because I was tired of changing the bulbs in my old one. I was hoping that with "10 diodes" they would get a lot brighter and my days of changing bulbs would be over. Not correct!

I bought these lamps in 2015 and they were wonderful. The two bright LEDs are fully encapsulated in epoxy for water resistance. THIS IS NO LONGER A BUSINESS! These headlights are now very cheap and have no splash protection! I am adding photos to show the old quality product versus the new cheap product! My advice to you: until Blazer stops selling junk, find another brand for maximum profit!

I bought these to replace the standard light bulbs on my daughter's horse trailer. Conventional lightbulbs suffer from both burnt bulbs and poor connections between the bulb and socket. This should solve both problems as the LEDs need to last a very long time and they are permanently attached to the board and completely sealed with some kind of epoxy. I have two smaller elements that I would change if I were designing them. I would make them a single wire connection first and rely on mounting…