Experience Ultimate AirPods Protection With Elago Dust Guard: Rose Gold Metal Cover For Wireless Charging Case [US Patent Registered] Review

Good idea just not executed well. I guess if the adhesive had lasted longer and stayed in place better then it would’ve been great but that wasn’t the case. The dust guard slowly broke off in pieces until I decided it was just time to take off the scraps that were left because pieces were breaking off and falling into the actual AirPod slots.

The difficulty that this thing was to get on *perfect*. It was frustrating. I think it was about 20 minutes of peeling it off and reapplying. I finally got it. It's important to feel into the pockets for the headphones to make sure you cannot feel the edge of the metal covers. If they are slightly off they could scrape your headphones every time you go to remove them.If they don't damage my air pods and they keep me from seeing that disgusting dirt that builds up it was worth it. But as it…

Extremely tedious to install. you have to align it exactly and there is not enough wiggle room on the iPod case. My fingers could not easily handle this task. You get only one chance to do it right and i failed. after a few days, it peeled and started sticking to iPods while keeping them back or removing them. I don't recommend this product. I think personally, it's a waste.

i first bought this product and they day it says it was delivered, it was not in the package but i really wanted them so i bought them again, only to find out that it does not stick and it is too thick for both of them to be on at the same time. When you put both on the case does not properly close and the size was not accurate. one side's surface area was fully covered but only to have the other side with nothing.

This product sucks I only had it for about three hours before they peeled right off like little cheap pieces of tape they do not stick well they cover up the LED light they are not worth a couple of bucks they are asking for I would not have paid $.12 for these don’t bother don’t waste your money do not purchase this product

This is a great idea because, I know that dust and dirt and magnetized pieces can get attracted to the areas where these two pieces go to protect. But they’re horrible while installing in the easily rip. So this requires a lot of patience.

When I tried to lift the sticker off the backing it ripped. Doesn’t stick to the case and it keeps lifting. Had to add adhesive glue to make it stick . Also becomes discolored very quickly even if you don’t use them as often because your baby constantly loses them.

Please do not! I REPEAT DO NOT! BUY this product it's a total rip off and super cheap. I literally touched it and it instantly ripped. So damn cheap. What a waste. They price it so high but definitely cheap material. Some things you just can't buy on Best Buy and this is one of those things. I suggest you just buy this product off alie express alot more thicker and legit material not cheaply made, oh also did I forget it's only for $2 for better quality. Yes it takes a long time to come but…

I don’t know why people complain on how difficult it is to install. Take your time and have a bit of finesse. Thanks for attention.

It does exactly as it says. Since it’s machined to fit very snugly into the case, it takes a lot of time to line up the stickers properly. I don’t have a huge issue with this as it took me about 10 minutes.

If there was a way to leave a 0 this would be the item for it. To say these are junk insults junk! You would be better off simply setting your money on fire in the back yard the results would be the same. There is almost no way to get these damn things to stick to anything but your fingers. Don’t buy.

Thin magnetic metal with sticky back, very hard to install took a few tries to get on but finally got it on Easy to clean and maintain!

It does it’s job, but my main complaint is that simply taking it off of the plastic it comes on most likely will rip it. Even with being careful mine ripped in 3 places. Of course after a couple of days one of the rips resulted in a portion of it being ripped off.

It is litterally just a sticker that has film metal in it. Due to the magnets in the iPod case, it is a pain to install correctly if you do not have a small pair a tweezers.

The look great at first, but started "rusting” after 3 months. This is after 8 months of use. They were also tricky to install.

They look great once on the product; however, the application and durability is not great. It took over 15 minutes to apply, even with instructions followed. Durability: my dust guard already tore as soon as I closed my AirPods and reopened the guard had a tear.

Great product, install is not nearly as bad as people make it out to be. Put your gorilla fingers away and use a small razor blade or something to softly shift it into place. The magnets will fight you, but that’s sort of the purpose of these. The base was easy. Top was a touch more difficult. Don’t touch the adhesive side and gently place it closest you can to it’s position. Then use something like a razor blade or fine tip to move it into its final spot then push down to stick. Great product,

Bought this for Father’s day for my fiancé. It took forever for you to install it as it’s very flimsy and hard to get it in place. It developed a rip after 5 days because even after it’s installed it moves around every time you open and close your case.Will be returning and getting my money back

They look nice once they are on but they don't look like they are going to last, mine ripped a little while putting them on. I give these less than a month. The magnets on the case don't make these easy to put on.

Took it off the packaging and immediately ripped on the side. no biggie made it work though but sucks that it happened and I bought two and it happened twice