🔌 High Quality Nilight 10011W 16AWG Wiring Harness Kit for LED Light Bars - 2 Leads, 12V On/Off Rocker Switch, Power Relay, Fuse - Perfect for Jeep, Boat, Trucks | 2-Year Warranty Included Review

Got these for my Jeep Wrangler TJ 03. They only have a switch for the light bar, I already had the standard switches for my fog lights, skirt lights and reverse lights. They didn't fit standard connectors so I had to do a bit of soldering and crimping to get them working. I had to order more wires for the reverse lights. I like the relay and waterproof fuse and they seem to be very durable. The headlights in my bumpers now work and everything went well. A fuse was blown when I got them but they

Nice set at a reasonable price. The instructions are good. The cables are sleeved and the switch is decent, but too big for my liking. If you can get a kit with a smaller, more discreet switch, I would recommend that. Overall I'm happy with the kit and would recommend it as a simple option for installing a dual fog lamp on the front of the car with the switch wires running through the firewall on the same side as the battery. But in my application I had to add 3 x 8ft of wire to the switch side

There are few downsides to this product. I was very happy with the look. The only problem I have is the rocker switch cable. It's very short, maybe 4 feet. My Chevrolet has the battery on the opposite side of the driver's side, so I had to lengthen the wires to get the rocker switch where I wanted it. It's not that important. Another thing I noticed is that power goes from your direct 12V supply to the LED backlight on the rocker switch itself, which is why the light comes on. Don't use it…

This is a harness that works as advertised. I use it to power two 6.5" LED headlights on my ATV. In my application there is a loss of play in the harness but this was easily remedied with a single zip tie. I like that extra fuses are included in the kit. The "tabs" that connect to the battery terminals are too large to fit snugly on small quad/motorcycle batteries, but this can be secured with washers. I'm also not a fan of the glowing writing on the switch, that's just my personal opinion…

This is for a dual wire seat belt. It was very easy to install, taking just over an hour. This is made from high quality, heavier gauge wire that will not fail or cause problems. The only thing I didn't like was that quick connectors trying to make quick connectors on bare wires really annoyed me, so I just cut them off the harness and used a heat shrink connector instead. Otherwise it was perfect for me. If anything happens I'll update this review. UPDATE on the second tourniquet! This is for…

You will be very disappointed if you think the cable length is right for your car. Your vehicle and light placement may be the exact same as they were given these lengths of cable with. It should be clear that there can be no universal wiring harness that fits all vehicles and all light, switch and battery locations. I was fully expecting to have to cut and splice the wires, luckily in my case there was enough extra length in places to more than make up for the wires being too short. There is a