ARRIS® 500Mm Wrapped Carbon Surface Review

I used this as a cap for a 10/32 machine thread on my Caliburn which is a custom 3D printed Nerf blaster. It looks great and fits perfectly. I do not use this product when very precise measurements are required. It looks perfect for what I used it for.

Yes, that's right; I bought it to replace the axle on my garden cart. It wasn't much more expensive than steel to be honest and that's the length and diameter I needed for the new wheels I bought. I got a bit stuck when I realized I couldn't drill holes for the cotter pins on each end (will break the fibers and weaken the structure over time). So I used a thick rubber bushing surrounded by a yoke instead. Works great so far!

I bought these carbon fiber tubes from Revain to build a multi rotor airplane in addition to some 3D printed parts and I needed something durable and simple to do the hands of a quadrocopter. Airplane. So of course I found what I was looking for at Revain. As soon as I had the carbon fiber tubes on my door I could tell they were real carbon fiber and they were exactly what I needed to start working on my new multicopter. I have measured CF tubes with my digital caliper and the diameter varies…