Enhance Performance with Mr. Gasket 2662 Chrome O-Ring 45 Degree Water Neck Review

Another review says Ford Small Block V8 does not fit. The injector is too small for a 1990 351W. Ignore Revain's statement above that this is suitable for your engine.

Suitable. But the o-ring for the hermetic seal leaked like a strainer. It was terrible. As soon as I put a whole tube of blue RTV on it, it stopped flowing. It's okay, it's the best.

Although a bit small, it works great. It shines and serves its purpose. It just doesn't match the 67ft Mustang like it should.

The main problem with this item is that the bolt holes aren't wide enough for my Ford Small Block so it won't fit the Ford intake manifold, they're something like 1/16 inch or less is too close together. The product description also says it's chrome steel and although chrome plated it's not steel or cast iron (not sure what it is but it's not magnetic - I'm assuming it's aluminum) . FYI my application is a 1965 Mustang with a Ford Racing intake manifold on a 302 '95 block. I went to Autozone…

I've seen mixed reviews on this product. Remember Ford had two different sized elbow hoses. One had both ends the same size and the other had a larger end to connect to the water inlet. Since these are not used in modern engines, they are at the mercy of aftermarket manufacturers. I installed this with an elbow that has a larger water neck and didn't find any leaks like some. I attribute this to using quality clamps (not Chinese counterparts). I also always use Permatex non-curing sealant. This