🚦 PLUG-N-PLAY Instrument Cluster LED Indicator Dash Bulbs, Aluminum Pilot Lights - 12V Speedometer Odometer Tachometer (Black Bezel, Amber LED) Review

I use them as fog lights on my motorcycle. Nicely made, lots of cables included. I bought amber at first but it distracts me because when it's on it looks like a warning light. Didn't want to switch to blue as it's the same color as the high beam indicator so switched to green. Amber was the perfect brightness but green seems too bright. You need to paint over the outer edge of the LED to lower the brightness. Definitely would buy more.

I installed this as a relay status indicator on the dashboard for my boat's dual battery charging system. It replaced a cheaper LED solution that was barely visible in the sunlight. You know the exact weather you want to be on the boat. Not only does it look better with the aluminum housing, the brightness is also perfect for my application. Seems to be well made and very easy to assemble. Good stuff, I'll look it up first if I need to in the future.

Beautiful and bright - even in daylight from several meters away. I have two of these installed on my electric pontoon boat, one on the console and one on the side of the boat next to the shore AC outlet. I use a small 120VAC to 12VDC power supply in the boat to start them up, which shows me the chargers are getting power. I can see the light from the kitchen window about 100 feet away - even during the day. They also offer good weather protection when installed professionally. Much better than

Installed this display on an ATV as a turn signal. It's compact, good looking and bright enough to be seen during the day. The two wires attached are Siamese and 22 gauge. The insulation is sufficient, but not for high temperatures. The light has good brightness. I installed it with stretchable PET braid to protect the wiring from rough handling. The wires were decent, I didn't measure but 3 meters was quoted. As for durability, time will tell but I think it's a well made product.

I ordered this item because my armrest and radio compartment are so dark at night and I don't want the bright dome to blind me. The brightness is just enough to see that there is an apartment there, not to bother with anything. Very easy to install, only need 12 volt power. I plugged it into the cigarette lighter so the light is on when the car is on and off when the car is off. The housing is black aluminum with an o-ring that helps hold the light in place while tightening the nut.

These turn signals appear to be of very good quality compared to some others that ship across the Pacific. They have a nice little o-ring on the top flange for a snug fit and a long cord so you can usually get to the power source with little fuss. The mounting nut is a thumbscrew, which seems to work well, but I would have preferred it to be a hex nut that could be hand tightened bareheaded. The brightness seems spot on, and against a black background you can hardly tell they're there until you

I replaced my warning light with this one. The overall body is pretty deep which is where you really need to look depending on where you place it. I wanted to install it behind the wheel on top of an ornament but needed to make sure there was enough room underneath. I could see this being an issue depending on where you want to place it on the dashboard. However, it is VERY solid. The aluminum body and rubber bushing are good. The diode itself is installed flush, so it is not visible at an…

I bought these for a '65 Mustang I'm restoring but I have an aftermarket dash. One of the turn signal LEDs on the dash was faulty and I couldn't find the exact one so I bought it. Two green for the turn signals and blue for the high beam indicator so they all match. These little lights are beautiful. Very well made and I love the fact that they have a ring that screws onto the back of the shaft to secure them rather than just snapping into a hole. And they come with a little rubber O-ring that…

I attached this to the brake light in the rear window of my car so I can see it in the rearview mirror. This indicates when my brake lights are on in the car. Its crisp red light is bright enough to be seen in all conditions but not too bright to be distracting. It has just the right amount of light and is made from a strong, durable material. If you're wondering why I did this, it's because I'm using an automotive brake light turn signal module with real-time brake force monitoring. In my…