TECO 🔧 20402PL Machinist T-Slot Components Review

step blocks are real 90 degrees. Imported brands don't stand still. They are ground at a slight angle from true 90 degrees. This causes the staples to put more pressure on a corner and leave marks on your products. Best buy on the market for the USA. Confused with Chin'e marks and nuts on the cheekbones allow you to screw the cleats into the table, Te-co has threads on the bottom and stops to keep the clamp screws from ruining the table. Another point of interest is the slots in the terminal…

, I just received this kit yesterday, looked at it but did not use it. This set fits perfectly into the 5/8" slots of my RongFu Grizzly G1007 Round Column Mill. The finish is a bit rough but only visually, all threads run clean and all work surfaces are even. T-slot anchors are not trimmed to full length which is right.no screws to over tighten.Made in the USA from powdered metal, the stepped blocks look clean and even.They have slightly sharp burrs on the sides where the molds have separated…

Do yourself a favor and buy this set. DO NOT try to save $20 and buy an imported set. Import kits are damn bad. I know I have an import set and I've seen other import sets. This Teko set is made in the USA except for the stand, the stand gets bad reviews but I don't know why, it's really good plastic and well made. The difference between this set and the $200 Teco set isn't in the blocks, as many uninformed people often say, the blocks are the same, the difference is in the lugs. 1541 vs. 4340…