Review on 🔌 Versatile 13-Piece Airbrush Adapter Set: Quick Release Disconnect Fittings for Air Compressors & Airbrush Hoses by Amanda Castillo

The range of adapters is quite good and they are related to my Creos/Mr. Airbrush Hobby PS-289 no problem. However, quick coupler stems do not have a standard quick coupler shape, which can affect their ability to attach to a quick coupler valve, as shown below. Connections and the airbrush ran under even the lightest weight, even under the extremely light rubber hose that came with my PS-289. On the occasions where it didn't disengage without warning and my $100 airbrush flew through the air, the quick connector would intermittently leak air unless the stem of the connector was pressed firmly against the bottom of the quick connector valve. No amount of teflon tape on any part of the assembly solved any problem. Also, the quick connect latch is not properly designed and instead of spinning freely or stopping in the fully open position, it opens past its open position. by turning off the air supply. There's also no indicator on the dial and case to let you know when you're in the "open" position (on/off directions only). The only way to know for sure is to see if the air is leaking from your airbrush. This makes setting up and troubleshooting color printing *extremely* difficult. I do not recommend using this valve and advise people to be very careful about how they secure their airbrush if they lay it down when attempting to use it.