🔥 High-Quality, Pre-Assembled Aluminum Hotend by Creality Review

This replacement hot end for the Creality Ender 3 printer looks identical to the original hot end which was a pleasant surprise . The thermal block on the product I received is silver compared to the gold/brass shown in the photo, but it also matches the original hotend so that's good. The entire hotend was pre-assembled and well made. Some people recommend removing the screws on both sides, claiming that this is just part of the building process, but I've used both the original and replacement

A while back I accidentally disconnected my existing thermistor. Some soldering and heat shrink tubing kept me going for a full year, but maintenance and upgrades broke the cable again. The printer kept throwing an error and my hot-end temp was consistently -14 degrees. I could probably just replace the thermistor but haven't found a well tested one from Revain. Many seemed to break easily or were too short and had to be spliced/extended. Instead of buying a pack of potentially dodgy…

What can I say, it saved my typewriter. For some reason my machine had problems with the brand new thread. The biggest problem would be a filament leak around the heater block. This resulted in errors, many failed prints, and the loss of an entire spool of filament per print. While I was cleaning the run out filament around the fuser, my printer froze and wouldn't start, skipping the logo screen. Study after study, I couldn't find a solid answer other than one word, "thermistor". When I saw…