National Hardware N325 324 Floor Stops Review

The doorstop works great. It also has a beautiful appearance, not flashy but very effective. It's a good weight too. Well made with rubber barrier

Be sure to measure the distance from the door to the floor. I didn't and the doorstop didn't work because the door was too high off the floor. It has nothing to do with plugs.

Get the job done. I chose lever handle springs and pads because floor stops are more subtle and, in my opinion, more visually appealing than spring doorstops.

There is no way to increase the clearance between the bottom of the door and the floor. A simple 1/2 inch spacer will do. Historically, bathroom doors were cut with a large gap to accommodate rugs. If you're making floor doorstops, you should look at where they're going to be used.

Used as a spare. The diameter corresponds to the size. There were issues installing it which was my problem but when trying to remove the screw the metal in the screw was so soft the drill bit just twisted in the hole so the screw couldn't be removed. The old screw was made of a much better material and I wish the new screw was made of a better material.

I installed these but didn't want to install screws in my new floors. I did it like this: I ordered a square tape for inside mounting. Four squares are required for the doorstop, two for the width at the insert and two for the height. You need to trim the squares a bit. Install, wait a few minutes and this pup is going nowhere.

The product has a good design and suits our purpose well. During the initial assembly, it turned out that the threaded pin rusted quickly. Upon closer inspection, it turned out that the "rust" was left behind after installation. I'm correcting my review as it was originally below when I thought the screw was rusty. A little note about the installation. This stop requires 2 holes. Place the stop where you want it and mark it on the ground. Drill the first hole where the screw hole is in the flat

Used as a spare. The diameter corresponds to the size. There were issues installing it which was my problem but when trying to remove the screw the metal in the screw was so soft that the drill just twisted in the hole so the screw couldn't be removed. The old screw was made of a much better material and I wish the new screw was made of a better material.

I installed them but didn't want to install screws in my new floors. I did it like this: I ordered tape for inside mounting in a square. Four squares are required for the doorstop, two for the width at the insert and two for the height. You need to crop the squares a bit. Install, wait a few minutes and this pup is going nowhere.

This product has passed the test of heavy traffic, adverse conditions and several months of wear-free use. the Florida elements, including heat, heavy rains, and even some harsh salty air) to keep the screen door leading to my porch from banging against the cobblestones. The door leads straight into the house and has probably bumped into the doorstep literally thousands of times. I went outside to watch it again while I was writing this. It looks the same as it did the day I drilled the hole in