Review on Seesii Adjustable Handheld Welding Charging by Bob Jensen

It almost does and has the potential to, sticks but doesn't stick so 3 stars for that. I feel like they made the wire cheaper, it seems a little small for a 10 AWG wire, I'll convert it to a pre-tinned 10 AWG wire and see if I can get better results, and maybe swap out the battery for an 8 amp hour 200 cell lipo amp. In fact, a range battery will probably do pretty well with it. The settings are simple, it will automatically weld 2 seconds after detecting a short circuit, and to change the welding power, just press the power button but until you get a flashing display from 1 to 6 (it has 6 gears, ROFL). Press and hold the power button to turn it on or off. the product I'm trying to brew: https://www.amazon.com/dp/B07QXJP787?psc=1&ref=ppx_yo2_dt_b_product_details I'll post more about it later if it works for me. UPDATE 5-24: NO will change the wire and power control mod on the board. Another thing I did was add 2 extra cells to increase capacity and current. The 10 AWG wire jumps quite a bit and heats up quickly, so I'll swap the 10 AWG wire for 8 AWG, which might help. Anyway I welded it tight with the tape I use but only on double trigger it's 2 times in one spot after 4 times in 2 spots, the rods are so hot you almost can't hold them . They should be fatter. Guys, this thing is unfinished! Oh yes the control board is similar to the 15.99 board here at Amazon, no LCD, low voltage and presets. So you pay extra for the battery and case. Up to this point it will not "weld" a 0.15 gauge strip well. UPDATE 5-25: Garbage didn't turn on. saved the battery and saved the cable, the probes threw away the rest, I don't worry about that anymore.