Review on Innovate Motorsports 3729 Heat Sink Extender by Shawn Jacobs

Manufactured with high quality. A few installation tips. If your connector is welded so that the point is close, try annealing the washer. Heat until it turns cherry red, then plunge into cold water. This will make the washer "soft as hell" and allow you to back out a little more from the extension. If the extension is far off, say 180 degrees or more, if you have access to a bench grinder, grind it to half its thickness, then anneal. Also, a scam panel that gives you more leverage can help you get it right. Incidentally, the flat areas for turning are 22mm, just like the Sensor 02.