Review on 🔧 Enhance Precision and Performance with Amana Tool 47092 Bearing Diameter by Andrew Grant

I wish I'd heeded other reviewers' warnings about the bearing 'moving away' from the cutter! Like the other reviewer, I had blown out this camp relatively early on when the cutter still had that new stench; and like the other reviewer, he also removed some of my expensive UHMW polythene templates, but I was able to reuse them. Unfortunately I wasn't so lucky with my expensive hardwood club! As usual I always check the tightness of the set screw before using the template cutter and I doubt this cutter took 5 minutes (which is well within the manufacturer's specs for the job). I can't remember my whole life why I bought this Amana Tool bit as I usually buy good quality Whiteside bits which are a pleasure to use and never give me any problems. . Well, go to the trash can to craft Razor Blades or Toyota Blades. This has also pissed me off with other Amana products as I bought their table saw blades but have now switched to Whiteside, Oshlun and could try CMT.