I bought it 1 year ago. I've seen probably 3 hours of use in half a dozen different TSF and fiberglass cures. It was ok but uses a decent amount of oil. As my first vice president, I don't have a basis for comparison, so maybe that's okay? Consumption is less of an issue than the fact that oil is shot vertically in a 1 foot diameter around the pump outlet. I set him on a platform made of shop towels to soak up some of the oil. The oil in it has been used up and almost gone, so it's time to buy more. Again, it gets the job done and I can hardly complain about its cost, but it makes a mess. I found this out after he oiled a trash can full of fiberglass, which of course makes this trash. It may have improved in the year since I bought it and may not be the norm, but it's an experience for me. I would buy again unless the best ones run out of oil, in which case I'd spend the money. If this is the norm, then I have no complaints. If it's typical, I probably can't dock it, hence 5 stars due to my ignorance of the specific expectation.
🔍 UView 560000 Combustion Leak Tester: A Reliable Tool for Efficient Diagnosis
9 Review
💪 Enhanced Universal R134A Valve Core Remover/Installer by Mastercool (81290)
9 Review
Lichamp Automotive R1234YF Installer Standard
9 Review
Robust Robinair (RG3) Portable Refrigerant Recovery Machine, 115V, 60Hz -Efficiently Recovers Liquid and Vapor Refrigerant
9 Review