Review on 🔪 4.5" D115mm Super Thin Diamond Ceramic Saw Blade - Superior Cutting Tool for Ceramic and Porcelain Tiles by Aaron Charlton

I originally installed this blade on a hard 7 carriage tile saw and got terrible cuts and vibration. I ordered the p4 beads but decided to try again believing they weren't set correctly so reinstalled, aligned the saw on the table and it works fine with a good life. Just finished a large-scale porcelain shower on the same blade and very satisfied, no problem, now I don't want to say that I got 100% perfect cuts, there were very small chips, but it was insignificant, and the tile looked like White Marble , I install a low speed diamond blade on my rotary polisher and the edge cleans up quickly and easily in a pass or two. It doesn't bend like flimsy blades, but if you have a crappy wet tile saw like mine, be careful not to pinch the tile. This is because your tiles will get pushed around, especially if you don't have a rubber pad on your table. I ended up ordering another one for the wet cutting hand saw I have and another for the grinder (which also has a p4 atm and I need to clean that edge too).