Review on 🌈 Glow in The Dark Heat Transfer Vinyl/Iron-on HTV for T-Shirts - 12"x20" - 2 Sheets, Total 40 inches - White to Green by Barbara Simmons

The vinyl is VERY thin making it difficult to detail the design overlay as the vinyl rises, and key design pieces can easily be accidentally removed even if you're very careful. In fact, I wasted a sizeable piece of 12 x 11 because, despite very slow and thorough weeding, several pieces of the design came out and couldn't be reattached. I then used this piece to test a spare t-shirt. I set the heat press to 305 degrees and pressed for 12 seconds. I waited about a minute before peeling it off and the backing sheet came up with no problem. I used a black t-shirt and the white color of the pressed design is not pure white, I think this is another result of the vinyl being so thin that the black color of the shirt shows through. Anyway, I needed a glow in the dark htv very quickly and couldn't find it locally. It arrived quickly and did the job but I'm not sure I would order again as I'm not happy with the potential loss if the weeding doesn't go well. I needed a glow in the dark htv very quickly and couldn't find it locally. It arrived quickly and did the job but I'm not sure I would order again as I'm not happy with the potential loss if the weeding doesn't go well. I needed a glow in the dark htv very quickly and couldn't find it locally. It arrived quickly and did the job but I'm not sure I would order again as I'm not happy with the potential loss if the weeding doesn't go well.