Review on 🔧 JSProxam Water Pump Impeller Kit for Mercury Mariner Outboard Motors 60-125 HP Models 46-43024A7, 46-8M0113799 by David Gill

This is meant to be a complete kit but does not include the top case gasket and gasket installation tool. Because of this I was unable to install the bottom unit and had to order and service additional parts. And as if that wasn't enough, check out the photos of the impeller housing. The first shows the new housing and shows how the cylinder liner protrudes from the flange face. And notice how the impeller sits in that space and therefore doesn't fit snugly against the wear plate. You can see how the impeller fits into the original housing and with this housing installed the impeller will fit snugly against the wire plate. The third photo shows that the top surface of the housing is bent from the edge of the cylinder wall just below the discharge grille. Again this is a problem as again the impeller will not stick to this surface as it is curved.