🔥 Abahub 236 Million 32 sqft Car Sound Deadener Hood Firewall Heat Shield Insulation Pad Automotive Sound Deadening Mat Aluminum Roll 118"x39" - Enhanced SEO-friendly Product Title Review

Very sticky but doesn't stick anywhere. Used to line my Mustang's firewall under the carpet. I put on long pipes, and the temperature under the driver's seat was 123 degrees. I have prepared my legs. Now the temperature reaches 89 degrees, a big difference. Also put it in the firewall where the vent is.

I found the product to be very easy to cut and adhered very well to the bottom of my hood. Let's see if the adhesive holds up over time/repeated heat cycles. I had a really hard time peeling it off, the backing was torn and I had to fiddle around to clean up some of the smaller areas that wouldn't come off on my first attempt at removing the backing.

The engine cover on my class A van has lost its old insulation. I bought this product hoping it would work. That works great! Heat and noise are lower than ever. It's very sticky, so that's good. The only problem was getting the paper off the sticky side. He wants to tear it down and leave the pieces behind. Not the end of the world, but that's the only reason I gave it an asterisk.

My class A van's engine cover has lost its old insulation. I bought this product hoping it would work. That works great! Heat and noise are lower than ever. It's very sticky, so that's good. The only problem was getting the paper off the sticky side. He wants to tear it down and leave the pieces behind. Not the end of the world, but that's the only reason I gave it an asterisk.

Used to replace the factory under hood heat shield on a tuned VW turbocharged engine. The OEM heat shield did the job (I thought) but was rusty and sagging. After moderate driving, the hood feels very warm. After intense driving in the sun, the bonnet stays cool with this new reflective heat shield. I was speechless at the difference such a thin layer could make. Very easy to cut with a utility knife and was large enough for my use. It is highly recommended that the surface to be protected be…

This material is easy to handle but quite fragile. This means that once cut, the aluminum can crack if you're not careful. It is highly recommended to use foil tape on the edges where it may contact holes where wires etc. run through. The thickness was ok. I've been looking for something thicker, but options are limited, especially if you're not spending a fortune. It seemed like decent value for money. It was also rolled up so the aluminum wasn't insanely crumpled, only halfway. Mine had a few