Enhance Your TV Viewing Experience with 9.8ft LED Strip Lights and Remote Control - Perfect for 46-60 inch TVs, Easy Installation with 3M Tape and USB Power Review

Don't know why this is rated so highly. The sensor on the strip must be positioned so that it is visible, otherwise you will have to stand by the TV and point the remote at the sensor to turn it on/off. The tape is ok, not very strong and the 'colors' don't match what you press on the remote. I will definitely switch to a better band later.

Advantages: beautiful colors. Enough options to work with. Cons: Remote access requires line of sight. I didn't really care because I wanted to put it behind the TV, pick a color and forget about it. However, the flashlight doesn't remember the last selection, so it starts blinking every time you turn it on. Every time you turn on your TV, you have to change the mode. Very uncomfortable.

This is a great product for the back of my TV. Works great in soft light. Ease of use and setup. The selection and the console do a lot more than I'll ever use. There was a problem with the remote control so I contacted Govee. They responded the next business day and immediately sent me a replacement. A company that stands behind its product 100%. Buy with confidence. I had an excellent experience in everything.

I specifically looked for a product with 3M adhesive but it wasn't on the turn signals. The lights are a bit small for my 50" TV, so I have a dark spot at the bottom. I wouldn't recommend a larger than 42 inch TV if you want the light positioned to the edge for maximum light. You could do this on a big tv but you have to dim the light on the back of the tv but the light then gets dimmer. I wish I knew it doesn't have really good glue

pass on as others have said the colors on the remote do not match the color output. It is plugged into a powered USB port on my TV. When it is turned off, it "blinks" randomly like a strobe light. It also randomly turns on by itself. The IR remote needs to be in line of sight to the sensor, I had to route the cable so the remote would send signals to the sensor which needs to be in line of sight. Side of the tape I had to buy double sided tape to install it on my TV. This is absolute nonsense…

I unplugged it after two days. At first it seemed like a great idea, but then the remote required a line of sight which isn't specified anywhere (who writes instructions more than Amirite) and I had to rearrange them and I couldn't change modes on all sides of the room. It's plugged into the only USB port behind my TV so I'll have to find another power source for my Chromecast as this cable is so short but to be honest, . Every time the TV is turned on, it starts up in this horrible strobe…