🖨️ eSUN 3mm Black ABS 3D Printer Filament 1kg Spool (2.2lbs), Diameter 2.85mm +/- 0.05mm, Black Review

Good colour. My child saw the imprint and called it "silver". But it's not round enough. My coil is 2.70 x 2.80. and diameters along the length are not very stable, so the volume changes during printing. I think the coil was wound too tight, maybe when it was warm. and it tends to relax like a deserted roulette spring. ok i'm exaggerating but it twisted a little and caught and messed up the print. And now my nozzle is clogged. I am not sure if it is caused by this material as it is a small hole

This thread works really well in my Airwolf3d v5.5 and Prusa i3 which have different hotends. The filament runs well at 233 degrees Celsius through the 0.35mm, 0.4mm and 0.5mm nozzles. I've noticed that the filament is less brittle at room temperature (68 degrees Fahrenheit) than most other filaments I have, making it much easier to work with when loaded into an extruder. I haven't noticed any problems with layer separation or unusual warping. The temperature of the heat bed ranged from 94 to…

First time using eSUN filament and although I didn't want to try this brand I was pleasantly surprised at the quality of the prints with it. Very consistent quality and prints from the beginning of the spool to the few meters remaining. For those interested in using this as an end product, the silver color is fairly flat, which can be good or bad depending on your needs. Even after intensive steaming, I personally would prefer it to be a little shinier, but I take the consistency and quality…