🦍 Gorilla Automotive 17TWS Thin Wall Impact Sockets 17mm Hex 1/2 Drive with Protective Sleeve Review

This socket broke on first use. I removed the eyebolts on my wife's Mercedes and the socket split on one side. The product looked good but didn't work at all. Do not buy.

This is the worst purchase I have ever made from Revain! I can't believe I didn't read the reviews before purchasing. That's usually the first thing I do. Be careful. Terrible product.

Should have read the reviews before buying. It broke on first use! I was trying to swap my snow tires on my BMW and couldn't even get a lug on it before it broke right down the middle. Very disappointed.

Bushing was not strong enough to remove and split over tightened nut. It's fine up to 85 ft-lbs, but if someone over-tightens at the tire shop, this socket may not hold up to repair the damage. Otherwise nice.

I needed a new socket for my BMW to protect my rims and I picked up this piece of junk. The first wheel bolt I tried to pry out broke off. The wheels were torqued to factory torque specs, so I didn't ask them to do anything complicated. Not even strong enough for a wheel bolt. Save your money!

This socket is a great solution for me, my wheels have very small nut holes. These are the only 17mm that will fit so I don't have to use slotted nuts. I've been using mine for over a year and have changed wheels over 100 times. My car is designed for drifting on the track, so the wheels are constantly changing.

The socket comes in a nice protective cover and looks good. However, it broke on the first attempt to use it. I was trying to loosen an eyebolt on a BMW wheel. Factory specs are around 89 pounds per foot. I can't say for sure, but I doubt the screw was over tightened. The car was only serviced by a BMW dealer and they had to get it right. After breaking that thin-walled head, I had no problem loosening the eyebolt instead of the stock 17mm head.