💡 D2S D4S D2R D4R D2H D2C D1S D3S D1R D3R D1C D3C D4C LED Headlight Bulbs Conversion Kit - High Low Beam HID Xenon Halogen Replacement - CSP 3570 - 20000Lm 80W 6500k Cold White Light - CANbus-Ready and Error-Free Review

UPDATE: Me and Revain CANNOT contact the seller for support as to why the H8 is not an H8 device. Don't buy it if you intend to use it. as a replacement for H8, does not fit and breaks, see photo!

bought for 2005 c230 mercedes benz 1.8 l compressor this bulb does not work for fog lights, when installed it starts flashing the bulbs can not stay on more than 1-2 seconds to cycle on and off constant. Contact Amazon, they will give me a full refund, I will try to buy other products and I will see that they are better than this one

I was trying to install LEDs and they are BOTH broken at the bend (90 degrees), both LEDs are broken in the same place. I personally don't recommend these. I have ordered LEDs for all my cars and have never had one like this. The LEDs also didn't have an adjustable clamp to make the diode vertical, which is important for proper beam projection. They seem bright enough. Just a faint design flaw I think. I would have to install a new set to give an overview of the brightness/throw/clarity…

Installed these in my KIA Soul 2012 fog lights! and they didn't work well. They looked bright when I looked at my car, but they didn't light up the road in front of the car. Because the brightest part of the LED is not in the same place as the filament of the halogen lamp. From a technical point of view, the LED is not aligned with the focal point of the reflector body. You can double or triple the brightness (lumens) but it can't be projected onto the road if the light isn't focused. I tried…

Well, for starters, they're nimble when they work. Less than 6 months after installation, a lightbulb started blinking and then stayed on at less than half brightness until it burned out. It was great while it lasted. The fit was a bit poor as I had to install a thicker o-ring to stabilize it in the case. Other lamps I've used in the same housing had no trouble installing. Customer service seems non-existent at the moment as they have not responded to my emails asking me to replace this under…

I want to give 5 stars to this product because it is very small and very bright. With them in my fog, I don't even need low beams. And they fit my 9007 (6500k) LED bulbs. I used to have a cheap set of fog lights and they were dull and colorless, they are amazing. The only reason I can't give this 5 stars is the metal ring that holds the bulbs in the fog light housing slips and slides off. I had to wrap tape around the ring to keep it from slipping and coming loose. The wiring harness fits well…

One bulb fit the body and the other didn't due to poor tolerances when machining the bosses on the bulb. I had to lay them down a bit to allow the bulb to fit in my headlight housing. The connector is also a bit further from the center line so my application to the bike resulted in the taillight cover not fitting without pressure, which made the seemingly fairly loose connection between the light housing and the connector weaker than the connector. connector on my bike. After all, they were no…

I really like the LEDs in my Polaris Sportsman 450 HO. However, you can see from the picture that the light distribution does not cover the same wide image as with an incandescent lamp. However, I must say that beyond that I do not notice any real difference when driving, since the area needed for the field of vision remains well covered and the LEDs even enhance the natural colors due to the higher color temperature of the LEDs. The high beam unit on the steering column actually led to better…