📺 InstallerParts Corner TV Wall Mount | 23"-55" LED LCD Plasma Flat Screen Monitor | Up to 132 lb | VESA 400x400 | Full Motion Swivel Articulating Dual Arm | HDMI Cable Included Review

Beautiful and durable. However, there is one design flaw that surprises me. The bracket that attaches to the TV and the other to the wall is very strong and reinforced BUT there are only 2 small screws connecting the TV bracket to the wall bracket and they are on the bottom. Makes me nervous as the hinge is at the top and these only 2 screws get a lot of stress as the top of the TV mount comes loose. We're going to attach the top of the two brackets together as there are no screws or holes and…

I custom made a corner TV center out of reclaimed wood and ship hull. Being able to mount our 55 inch TV in the corner was critical to the success of this project. The wall mount was exactly what I expected. It seems very strong and durable. A 55 inch TV should be the maximum size for this project. standing, and I agree. We left some room on the side to allow the TV to move sideways (about 5-6 inches on each side). I work from home a lot so setup and installation didn't bother me. However, I…

I installed a corner TV mount yesterday and am happy with the result. I installed my 55 inch TV after some deliberation, not sure what type of mount to use. I was concerned that the corner would be too tight and the mount wouldn't extend far enough. It wasn't a problem. However, I measured the room, TV and extension from the corner and was within range. I used to assemble and disassemble TVs and it wasn't that difficult. Find the bolt, drill, align the screw. I made sure to line up each hand…

I used this product to mount a 55 inch Samsung Series 6 TV. This is a quality, durable mount that fits well at an angle. I noticed that the 55 inch TV was as big as it gets. Walk without touching every wall (the actual location of the studs can also make a difference). The instructions were poor - the fine print was very difficult to read and the pictures were very "busy". I ended up resorting to a YouTube video, which worked well. I only needed the middle screw mount so I had a lot of hardware

The bracket itself is good. I had a problem with the mounting hardware. Wall anchor bolts begin to twist plastic drywall insert and do not tighten. I had to buy higher quality inserts for the walls. It is much easier to install when screwed into the wall with studs. Even using the cans I bought I wasn't sure if they could hold the weight so I installed both sides on studs in the wall even though the geometry wasn't 100% symmetrical. One post was 16 inches from the corner, and the opposite wall…

The good thing is that the mount itself looks very solid. It solves really problematic layouts in an original way. All gear is included and most of them are of really good quality. Despite a really disappointing installation, I recommend this device. They're not text based, even where they absolutely should be, and to make matters worse, the images are illegible. Spoilers: to avoid daydreaming, install one mount and then the other instead of working on both at the same time. Ugly: Wall anchors…