Malida FBA_646455 Filter Aquarium Supply Review

I bought this not knowing what to expect and was under the impression that it would be larger than it actually is. I use it in an old evaporative cooler that drips water and no matter how I adjusted the old valve that was made specifically for this application I could never get it to work properly, I would adjust it to have a certain level. and the next day it will fail, and the soil under the radiator will be saturated with water. After I installed it, it works perfectly and doesn't leak at…

. I bought this to add my reverse osmosis filtered water line to a Kuerig K-Select coffee maker. The K-select's water tank is very narrow but holds a couple of inches more. As others have pointed out, water seeps in at the top where you screw the adapter into the base. Many have commented on the use of duct tape, but I actually found that a size 5 o-ring placed in the female side worked very well. Once installed, it worked exactly as expected. When I press boil you can see the water level go…

I got tired of refilling our Breville espresso maker so I bought a new water tank (about $25) and removed the water filter assembly as I use an in-line filter for water . for plumbing. I drilled a 5/8" hole in the top to make sure the float valve had play all the way around. Installed a float valve and used a 1/4" plastic water pipe with a shut off valve. It runs under the sink to the built-in water filter, which is separate from the icemaker line to the refrigerator. While it works great. The…

I installed this mini float valve on my Keurig water tank to make it auto fill. This little valve works perfectly. The valve itself requires a 5/8 inch hole for the mounting shaft to pass through. I lightly drilled the hole with a step bit similar to the Vastar Step Cone Bits, HSS, 10 Pitch 1/4" to 1-3/8". They are great for cutting holes in thin plastic as they progressively cut a hole in the plastic with very little stress. You tighten the valve body with a plastic nut that compresses the…