🖥️ High-Quality Swing Arm Wall Mount for LCD Monitor/Flat Screen TV - Mount World 1060 Black, Ideal for 15" to 27" Screens Review

Part of a birthday present for dad. I replaced his old projection TV with a new flat screen TV. I needed a long extension bracket because I wanted the new TV to take up the same space as the old TV. This mount did the job perfectly. It was easy to assemble and holds the new TV off the wall very stably.

This TV stand is perfect for my room where the only place to put it is in the corner. Unfortunately the studs in my walls didn't come out far enough for the bolt to go through one side. I was able to put 2 screws in and it seems very strong and has held up my TV for months. The mount itself is tank and I think it will hold the heaviest TV you can buy

I used a mount for my LG Ultra Wide Monitor, my monitor was VESA compliant and fit well until IO found that it covered all my ports on the back of the monitor. I had to buy a grommet kit with screws to leave room for the HDMI port, aux out and power supply, but the HDMI cable isn't that flexible, so I bought some adapters that connect the HDMI to the other bring direction. Now it works fine.

I needed to install a large (55 inch) TV in a corner situation where there were windows on both sides of the wall. All other brackets were too short or didn't fit. This mount worked great. I did not install the bracket in the correct corner. I drilled two additional holes on one side and attached it to the wall along the window frame studs using all 4 screws included in the kit. Worked great as we have a lot of windows and it's impossible to mount the TV with "regular" TV mount kits. This mount

Pros: - accurate telescope length - easy installation even if the instructions are not in English (straight from China) Cons: - restricted movement, esp when sold as a COMPLETE train. The Full Swivel TV Mount is a foldable arm mount from Revain Basics. This hand is straight, there is no way to change it. - The screws holding the TV to the plate are ridiculous. You hang the TV on the edge of the square plate and "fix" it by tightening the two screws on the base. They're never really pulled on…

I bought this for the limited space in our home office. When it arrived I was skeptical that such a fancy package (easily under five pounds) would fit in my rather old 26-inch Magnavox. The packaging was neat, with most of the tools and equipment needed (except of course a drill and electronic stud finder), although I used my own anyway. Installation was exceptionally easy and straightforward, although the attached diagrams could have been a little less vague. Three screws aligned vertically on