🔧 Rectorseal Pipe Repair Kit 82112 Review

small hole on the metal tube, we followed the instructions exactly. It did not work. Of course there is nothing to return as it has been used. However, please note that the purchase of this product is a one-time process.

No putty was needed to seal the hole. Tried using heavy duty construction glue and then wrapping it around. It did not work. Very disappointed because when all this is done you will have to saw off the pipe.

sufficient product for a repair. The leak should be depressurized during the repair if it is a pipe. If water drips, it floods the material and continues to flow. It's like casting a broken bone and needs to be applied quickly with disposable gloves on. It really works when used correctly.

Follow the instructions when using this product and make sure you are ready for every step of the process. It is incredibly strong and will take a lot of effort to remove once it has cured. The gloves that came with this product ripped on me so make sure you have good quality gloves before you start as this stuff will set on your skin like super glue.

I run apartments and a company told me it would cost $1500 to replace the outer pipe because it was under another set of pipes on the sidewalk and they would have to take it everything to get to it. I bought your kit and we made it myself for the cost of the kit. That was 5 years ago and is still going strong. Now I always make sure that it is at hand. WE use it to fix sprinklers, drain lines and everything else. Easy to use but you must follow the instructions EXACTLY. And don't be such a…

Proven rubber patch with radiator hose clamps; tried a U-shaped yoke with liners; tries to solder. They all slowed the leak but didn't stop it. I installed a baseboard hot water radiator from, say, a less than considerate contractor who was never heard from again. and one of the tubes was never soldered to its terminal, resulting in rapid dripping when heated. It was the middle of winter, so I didn't really want to turn off the heating to drain the water from the system and solder properly. Big