🕹️ Optimized Jamma Board Standard Cabinet US Wiring Harness Loom for Jamma 60-in-1 PCB Board by RetroArcade.us Review

Drawn letters and numbers start rubbing off when you rub your fingers over them. It's good that everything is written in English until it's deleted.

I ordered two wire harnesses because it was described as the power cords would be 18 gauge. You are not! Power lines 20 gauge. Basically a cheap substitute and misleading description or bait!

The wiring harness worked as expected. All options (which I wanted to use) were checked. It was wrapped in bags with player one and player two. It took some trial and error to figure out the buttons. Both test and service wires. connector labeled in Chinese,

I bought this product based on reviews. Yes, the numbers are in English, YES, they are erased, I found about 12 button connectors have no continuity? They are crimped onto the insulation, not the wire. Does it fit, yes, take a picture of the marker first before it gets deleted. Also check each wire to make sure it has continuity. Hours wasted looking for it. Another thing is to make sure it's installed properly as it doesn't have a cutout to place it on the board so you can install it upside…

I will not use JAMMA again after this harness. Three reasons: 1.) The cables are labeled in English. Granted, I remembered the pinout from JAMMA, but it's nice to have English notation nonetheless. 2.) Unused wires can be pulled out with needle nose pliers. These straps usually have molded metal lugs, but they more closely resemble innards (and are therefore removable). Better than just cutting the used wires because you can put them back in if you change your mind. I like a tidy setup, and if…

I bought this harness cheaply and used it to connect the WINNT 60-in-1 JAMMA board. All the minimum required features for a 2 player arcade game are available with this trailer. Cable quality is good and doesn't feel cheap. Inexpensive? Yes. Cheap No. Please note the following though and it doesn't necessarily make a product bad or cheap! It may just not be suitable for your arcade application.1. This is not a complete wiring harness and cables for unsupported functions are not included. For…