🚙 Rugged Ridge 17235.56 Switch Pod for Left Hand Drive Jeep Wrangler JK (07-10): A Pillar Accessory Review

The capsule itself looked good but was stamped with an "R" for the right hand but I ordered the left hand. The left hand is also indicated on the box. Someone screwed it up. I didn't realize it until I disassembled my rack along with the switches. When I received my replacement the color was off and it didn't fit like it came from the factory. Look at the pictures and decide for yourself. It's the best choice on the market, but they have to tell you it doesn't match your standard 2007 interior…

Product as described, goes well with my 09 JK Unlimited. The only real issue I had was that the distance between the switch cutouts needed to be longer for the laser engraved blue LED key switches I bought. The cutouts were certainly stiff, but they were great for toggle switches. The Dremel tool and utility knife got the job done in a few hours. The Mictun rocker switches had to be filed to fit on both sides. If you are having trouble feeding the switches down please purchase the switches…

Nice addition to driving high/fog lights etc. Installs fairly easily and the color match is close but not perfect. Now for the problems: The inside edge (where it meets the windshield) was deformed - I overcame this by rolling up a paper towel and filling in the inside/top cavity and then screwing in some screws to connect the brace and the factory parts together. The other issue is that the warp also causes the strut to move 1/8 inch when the door is closed - it's a Jeep so I'm used to "living

the title says black. I went with the article title instead of reading the fine print. it is grey! I'm very frustrated with this because I have to do a cross country road trip in a few days and have to set some switches and I'm stuck with this crap. The color matching is not even close! With the same success it would be possible to make a white trim on a black interior. I've spent a ton of bucks on Rugged Ridge mods on my Jeep and they've all been a bit disappointing. then there was this…

Pros: Hard to say - I haven't installed it. It seems to fit, but I can't say for sure. The packaging was ok - nothing special but sufficient. Instructions included. Cons: Does not fit in the interior of the car. Not even close. Medium gray is not black. It would look just as out of place if it was pink or yellow. As others have written, the switch panels don't slide out either - they're molded in. They need to be cut out. I personally don't think it matters much. But for end-user convenience…

My switch box showed up and I was happy to fit it into my JK. After spending almost an hour cutting out the tabs for the switches using a Dremel rotary tool, a file, a razor blade, and some elbow grease, I was finally able to install the switches. Then, after struggling to figure out the wiring, I put the control box back in place in the jeep and found that the control box was deformed. It leans too far towards the driver's door and shifts every time the door is closed. Also, the right side of…

Purchased to install switches for auxiliary lights on the front, sides and rear of my 2007 Jeep Wrangler. I like this arrangement of switches more than the lower center console (you either have to memorize the position of each switch or look down - not cool). Easy to install and I found (unlike some others) that the color matched my original finish very closely. To make things easier you need to run the wires to the lights (or other device) first and connect to the switches last and then attach