🚗 Water Resistant LED Parking Sensors - Car Auto Vehicle Reverse Backup Radar System, Sound Warning, Anti-Freeze Protection, 22MM Diameter Sensor, 2.3M Cable X68D (Grey) Review

First I bought two of these sensors and sent them both back; one had a damaged power cord and one had no power cord at all. Two backordered, however there were two different versions of the sensor; One pack came with a monitor (buzzer) which has a switch to turn the buzzer on and off like the ones ordered the first time, while the second set does not have a buzzer switch. I do not recommend this seller.

The controller can be too sensitive to randomly indicate the distance to obstacles with an annoying beep if I just stand in reverse and clear the distance behind me. The rubber fasteners of the sensors are too soft, they are light The double-sided tape for the controller is not strong enough, falls off after a few minutes, it must be replaced with 3M all-weather double-sided tape. satisfied feeling.

The reversing sensor works as expected. The red basically matches the bumper color of my 2004 F350 and looks nice. I recommend using a Unibit instead of the included cutter. Ring cutters don't cut steel as well. Use a cotton swab and some primer to sand down bare metal after the holes are drilled. Once the primer is dry, use a bit of touch up paint if you feel the need. For power, I just tapped on the reverse light wiring harness. As an extra measure to prevent the sensors from falling out of…

Product works as advertised. Recommend the following: 1. Include two wire connectors for the power supply line.2. Plan an additional meter of cable for the power supply line. My brake lights are on the trunk lid, so when I hooked up the power wire near the brake lights, I was missing about a meter of wire to the ECU.

The controller may be too sensitive to randomly display the distance to obstacles with an annoying beep when I just stand in reverse and the distance behind clearly see . The rubber closures of the sensors are too soft and break easily. The double-sided tape for the controller is not strong enough, falls off after a few minutes, needs to be replaced with 3M all-weather double-sided tape. I might pay more for a better product than where it shouldn't be a cheap product but a less satisfied…

Reversing sensor works as expected. The red basically matches the bumper color of my 2004 F350 and looks nice. I recommend using the Unibit instead of the included cutter. Ring cutters don't cut steel as well. Use a cotton swab and some primer to sand down bare metal after the holes are drilled. Once the primer is dry, use a bit of touch up paint if you feel the need. For power, I just tapped the reverse light wiring harness. As an additional measure to prevent the sensors from falling out of…