🐯 Tigeracing Retractable Truck Bed Top Side D Ring: 2019 R-a-m 1500 (Classic Model Only) and 2019-2020 R-a-m 2500 3500 - 3000 lbs Capacity (Set of 4) Review

Just bought these for my 2019 Ram 1500 CLASSIC, not a new body. I had to cut all 4 holes with a razor, which is longer than when I installed them, but one day I liked them. They seem super strong and look great. They are not flush with the bed linen guides, but lie on top. Very happy with my purchase!

The cable ties are made of high quality stainless steel and aluminum. Good equipment. Installing 4 out of 6 was very easy. 2 requires some plastic timing on the truck. My Ram came with black plastic comforters (and a dusty inlay). The two rear holes required me to cut about an eighth of an inch of plastic from the inside of the factory cover. I used a simple utility knife. Holes are rectangles, both short lengths of each rectangle take time. But they are very easy to combine on site.

I bought these for my 17 year old RAM 1500 as Revane said they would fit without cutting off the rail cover while others needed them. However, when I inserted the first one into the rail cap, it didn't seat properly, being about 1/32 inch too big. Luckily with some lube and a rubber mallet I was able to get them into the post holes with plenty of elbow grease and then screw them in. Had I known it was necessary I would have bought different sets.

Anchors appear to be well built and strong. I ordered 4 but need 6. Other than that I'm happy to order 2. It was a little tricky to install in my Ram 3500. The 2 holes closest to the cab did not require any further modifications, they could only be convinced by unscrewing the 2 fixing screws and inserting them at an angle. The 2 rear holes required removing one side of the black rail cover in the hole. Then get to work as before. The washers are easy to lose when removing the screws as they are