URO Parts 25117580281 Shift Rod Joint with Lock Ring, Foam Bushing, and Integrated Shims Review

Piece of foam needs to be trimmed heavily to fit even where the pin goes in, needs trimming to fit, might be ok after trimming what anyway took my buddy and me almost 4 hours for a job that was supposed to take 20 minutes max

Foam piece needs to be cut hard to fit, also where the pin fits needs to be cut to fit, can be fine once cut Overall it took a while Me and my buddy almost 4 hours to complete the job which was supposed to take 20 minutes max.

Bad, bad, bad. The hole for the mounting pin was too small. There was too much foam in it. C The clip that came with the kit was of poor quality. The inner "sleeve" broke off when trying to install. I ended up sending it back and reusing a quality original BMW. Stay away.

So this product represents excellent value for money. There were 2 issues I encountered when installing this on my transmission. The yellow foam inside was a little thick/high inside the joint. I had to take it out and peel off a piece of foam twice, not hard enough to be able to put a Dow pin through a hole in the hinge to lock it to the gearbox. The problem with the rogue I know was that the C-clip that was on the new pivot point was a bit loose in the area where it was supposed to keep the…