💨 High-Performance Onboard Air Kit by VIAIR Review

Nice little setup. Pretty easy to install and I put mine in a fork to remove from my bed 5th wheel fork when I need it. The compressor is great! Super comfortable. The "air system" package was a waste of money as my pressure shutoff system isn't working. I even hooked it up to a pneumatic tester and looked at the voltages. Definitely broken and sent to me like that. Everything else works fine, but I can't just turn it on and ignore it. What I'm going to use it for shouldn't really matter, just…

This is the second Viair tank and pump I have bought. The first still works in my 2008 Silverado HD3500. I also installed a truck horn in case you tow it and need more than the stock horn! When I towed a 5 wheel RV I wanted to be sure I had air and it has paid off multiple times. There is also a 20 ton air jack for the axle and it works great. I now have a 26ft Class C and just installed this unit under the frame and it is now ready to jack up and air as needed. Great product and the package…

This is basically a complete kit for some installations, but your particular installation may require a trip to the hardware store. This is not a disadvantage of VIAIR, but don't expect to just install it without a plan. However, I installed it in the back of my truck between two large mattress support frames. After carefully considering the options, this was my best spot. I can add a photo later if anyone wants to take a look. I installed this on my 2019 F-150 XLT with a 4x4 extended cab and…

I am currently using this on Hadley Ambassador air horns. My factory Hadley compressor failed so I upgraded it to a better compressor and combined the tanks into a 3 gallon tank. Fills three gallons from empty at 150psi in approximately 3 minutes 48 seconds. Just be careful where you install the compressor, the handle/head/metal plated air line will be very hot. They offer a large number of air lines and fittings. I found that the number of wires from my driver's side battery to under the back…

I installed this on my 2007 FJ Cruiser as shown in the photos. I believe the full install took about 6.5 hours with all the brackets made. Without access to a good store it would be much more difficult. That works great. I would highly recommend this to someone with good DIY experience and access to a decent shop/tool. I made a few modifications along the way to get exactly what I wanted: 1. bought an extra quick disconnect kit to have one on both ends of the hose2. removed the sensor and…