WeldingCity Welding Stinger Replacement Clarke Review

Had to trim the liner a bit and hook up the switch wires but it was easy to adjust, worked great. This is a major upgrade from the 6ft gun it came with. My only complaint is that the trigger is difficult to pull. Overall I am very satisfied, although I can recommend it.

Seems to be a pretty decent gun. I definitely like the longer range. No big deal, I just put an old fork in it. Plus it seems pretty good!

Where the guide was crimped the wire did not go through. I even tried a smaller wire. I recommend checking the quality at the factory. Also, it looks and feels like a quality product, too bad it's defective. Another week without a welder.

I bought this for my Clarke 130EN welder, the only real downside was the argon hose was too short to reach even outside of my welder. I found these 10 uxcell 4mm to 4mm straight push-in fittings, quick disconnects seemed to work well with 4mm argon tubing. Just wanted to help others in case they encounter the same problem. Please note the link on the Revain mobile app doesn't work: look for (straight plug-in uxcel air 4mm to 4mm connectors) they're cheap and seem to hold up well .

Since it was new years ago this welder has never welded very well and is worn to the point of being unusable. This replacement MIG gun was not made for a Schumaker welder but looked very accurate so I bought it to see if I could rebuild it to fit. A few simple modifications like connecting the new 2 wire trigger wires to the single wire trigger by isolating the second wire that connects to the main arc wire on the old gun body. It was easy and natural. The wire guide tube matched the old clamp…