🔧 Enhance Your Grinder with Yakamoz Converter Attachment Accessories Review

I bought this one because it was half the price of the dremel brand but it looked the same, I needed it to cut up tight spaces under my car Steel pressure hose. I have a Teccpo rotary tool that for some reason stops spinning when the cutting wheel gets stuck or meets a lot of resistance and that was exactly the problem I had with this adapter, it has enough resistance with my Teccpo tool done to stop him. I had to add some WD40 to the adapter and play around with it a bit before I could get it…

No instructions available. A little tricky to install on my Dremel 4000, here's what I did: On the 4000, unscrew and remove the cap over the collet and nut. Unscrew the square adapter cap and fitting where the original cap was removed. Remove the collet that came with the square adapter spring bar (mine was sent with a collet on the shaft not compatible with my 4000, don't know why, never used this new collet, in fact it was wrong in transit hereabouts.) . Insert the spring bar with the rounded

I would give this one five stars if the first one worked. Had to order a second one due to poor quality control. The Yakamoz square converter fits both of my grinders, but you have to play around with the square cord that goes into the collet so it doesn't press against the top of the tool when you tighten the nut. I had to order two because when I removed the collet nut (or collet chuck for you purists) not only was a socket wrench required, but it was also impossible to unscrew the threads…