Review on Baomain Industrial Signal Warning Indicator by Lonnie Batch

I had to buy them to find out the circuit diagram. The schematic on the box does not fully describe the wiring details. After testing, the box's circuit works, but the light is very dim, except for the green LED. The box also describes other light poles with different light colors (blue and white) and gives the colors of the wires. I couldn't figure out what wiring scheme to use due to missing many wires of the same color coming from the light tower. The wiring is detailed on the packaging as follows: Gray and Red = Low Red LED Gray and Orange = Very Low Yellow LED Gray and Green = Light Green LED Gray and Violet = Buzzer On For best results when used as directed, use the following wiring configurations: Wiring PERMANENT ON: Red (with a pair of black wires) = Red - Power + for Red (negative), Yellow (negative), Green - (negative), and Violet - (negative) Red - switched to power - ( Earth ) = bright red LED on yellow - switched by power- (ground) = bright yellow LED on green - switched by power- (ground) = bright green LED on purple - switched by power- (ground) = buzzer on (buzzer is louder) similar a high pitch, like the high keys of a piano right side) Gray and black wires = unused STOP-ON wire Connector: Red (with a pair of black wires) = Red constant Power+ and black constant Power- (ground) Red-on with gray wire t = bright Red LED flashing on/off Yellow-on with gray wire = bright yellow LED flashing on/off Green-on with gray wire = bright Green LED flashing on/off Violet-toggles gray wire = buzzer on/off gray intermittently Cable = used as an intermittent signal to ground Also: Length (light tower only): 12.250 inches Diameter: 1.968 inches Light tower support stud threads: 16 mm x 1.5 mm with contact threads 15 mm deep. The 5/8" diameter hole must match the mounting hole snugly if you are not using the included hardware. Mounting hardware is also included 2 thin zinc plated steel nuts (16 x 1.5), 9.75+ inch hollow aluminum tubing, zinc plated mounting bracket and 16mm hole zinc plated steel washer. The wires run approximately 24 inches from the base of the light tower. I hope this helps anyone looking for these specs for this light pole.