Header banner
Revain logoHome Page
Adam Wojtczuk ᠌ photo
1 Level
340 Review
0 Karma

Review on ASRock Authorized RX 6900 16G by Adam Wojtczuk ᠌

Revainrating 5 out of 5

Just super, the product is made wonderfully, very satisfied.

Please note that the card, no matter how much more efficient it is than the 3090 in terms of heat dissipation. still can do 300W+. Therefore, do not expect that everything will be ok with temperatures in a stuffy building. I have stock 2x140 blowing and 1x140 blowing in a fractal and their efficiency is not quite enough. A slightly ajar window (it is possible in my case) lowers the operating temperature of the chip from ~63-64 to ~55-56 (in my conditions). In general, about the 6900: I have never been a fan of AMD cards, but . this is just chic. The native software works fine. Nothing freezes in games, nothing crashes. It’s clear that in RT its level is between 3070ti-3080, but firstly, it’s not over yet and we all know how AMD likes to finish software after a while . and secondly, in native loads it’s a competitor to 3090 for much less money. Using 2K165 after 2080ti got a noticeable increase for a minimal surcharge. (Comparing them in warzone - even DLSS of the "balance" level did not allow getting such a number of fps + it turned out to use almost all 16GB of memory to send a bunch of moments from ultra settings to the buffer, which 8GB cards can't even dream of)

img 1 attached to ASRock Authorized RX 6900 16G review by Adam Wojtczuk ᠌



Pros
  • + CO efficiency, though only 2.5 slots. (It’s not a stove, it doesn’t yell, but I advise you to immediately adjust your curve, because the stock scenario is bad. It allows the card to heat up to 60 and then starts to cool. It’s easier to immediately give speed if the card is under load without critical victims in silence) + No obvious squeaks, rustles, etc. (Closer than 80 cm to the body I do not sit)
Cons
  • In general, the design is for an amateur, but in our time it turns out to be more likely to buy what is available and cheaper, and not what fits perfectly into the assembly. The valve would be central matte, otherwise the backlight gives off cheapness.

Similar reviews