Review on 🕹️ Optimized Jamma Board Standard Cabinet US Wiring Harness Loom for Jamma 60-in-1 PCB Board by RetroArcade.us by Justin Woolley

I bought this harness cheaply and used it to connect the WINNT 60-in-1 JAMMA board. All the minimum required features for a 2 player arcade game are available with this trailer. Cable quality is good and doesn't feel cheap. Inexpensive? Yes. Cheap No. Please note the following though and it doesn't necessarily make a product bad or cheap! It may just not be suitable for your arcade application.1. This is not a complete wiring harness and cables for unsupported functions are not included. For example, additional fire buttons #5 and #6.2. The wiring harness does not protect well from an improper connection to the board. You need to ensure that the group of thick red and yellow power cables are facing up and towards the top left corner of the board when holding the board right side up with the VGA monitor connector facing you.3. There is no English description on the tag. Covering the plastic connector with painter's tape and marking the terminals while looking at the wiring in the JAMMA board manual will ensure hassle-free wiring.4. The crimp terminals on the wire harness are smaller 3/16 inch knife blade connectors. If you want to connect a 4 inch speaker, you may need to replace the 3/16 plug with wider 3/4 inch plugs as most speakers come with 3/4 inch plugs.5. Finally, the button wires for 1 player and 2 player can be the same color (brown in my case). So make sure you figure out which wire goes where so you don't mix up the 2 buttons. The same applies to (+) and (-). ) speaker wire (I had white ones). All in all, a simple, handy harness that works with a very basic arcade machine setup!