As expected this case/piss cap is pretty cool for the amount paid. I wish it came with a joystick or other triggers, but other than that it works as advertised. I will say that if you buy this item you should be prepared to do some research as no instructions are included. Luckily, I'm a techie and a Google wizard. I managed to figure out how to set up the GPIO buttons on the Pi-Hat. For your Raspberry Pi 3 you need to edit this file called recalbox.conf which is on your SD card. Then find the line that says controllers.gpio.enabled=0 and change 0 to 1. Then restart it and go to the Recalbox controller settings and map the button layout. After I did that, everything worked perfectly.
🎁 Ultimate BBC Micro bit Sensor Starter Kit: Keyestudio 37-in-1 Box with Tutorial, Compatible with V1.5 & V2, Gift for Kids and Adults (Microbit Board Not Included)
11 Review
GeeekPi Raspberry Pi Cluster Case with Cooling Fan and Heatsink for Pi 4 Model B, 3 Model B+ & 3/2 Model B
11 Review
🌐 MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
LAFVIN Super Starter Kit for Arduino R3 Mega2560 Mega328 Nano with Detailed Tutorial - Compatible with Arduino IDE
11 Review
uxcell 3.5" HDD Screw Black 200pcs for Computer PC Case - Flat Phillips Head - 6#-32 - Hard Drive Fasteners
10 Review
Glarks 660 Pieces Phillips Assortment Motherboard
10 Review
36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review
MacBook Retina 13-inch (A1425, A1502) and 🔩 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review