Review on 🔧 High-Quality Qty (2) Rear Trunk Lift Supports for IS300 IS250 IS350 2006-2015 (non-convertible) - 6453053010-6453053032 PM1016 by Evan Beougher

Clips not included but if you are careful you can reuse the clips. All I used were pliers and a flathead screwdriver. This took about 10 minutes. I will provide my steps I took (this is not a guide but a process I took to install, I am not responsible for any damage caused by what I have to share) 1. Remove the 3 flat clips that slide towards you (easily)2. Remove the 2 round clips, one on each corner near the light, it will have 2 push clips holding it in place (easy) 3. Carefully pull down the trunk lining, there are a couple of clips on it (easy) 4. Remove the plain clips (quite hard, not a lot of wires) 5. Take a flat head and remove the black clip from the rack on the torso, it's a black C shaped clip (same for the other side) 6. You must gently bend one side of the silver clip to remove it. I just used a flat head and gently lifted it up. (same for the other side) 7. Stand slides8. Reuse the silver clips and gently bend the clip into place after installing it on the new rack.9. Slide the post to the innermost attachment point10. Press on the post to release the ball end so you can attach it to the ball mount. Overall it took about 10 minutes without unpacking the rack. The ball joint is pre-lubricated and good luck everyone!