Review on ⚡ InstallGear Power Distribution Block - 4/8/10 AWG Gauge, (4) 8/10 Gauge Outputs by Dezz Watson
Hard Fir on Stranded Copper
Connects one input and 3 outputs of 12 gauge stranded copper. First of all, the attachment inside the screw contact was not strong enough. I ended up having to cut the insulation off the end of the wire and doubled it for a larger diameter. Then it fits well and holds tight. When tightening, the thread split in half and was easily pulled out. I find that solid copper wiring is perfect for those little set screws.
- Free for educational purposes
- Much
New products
Comments (0)
Top products in 🚙 Vehicle Electronics Accessories
SilverStone F1 Monaco S radar detector
82 Review
Waterproof Hard Laptop Sleeve Case For MacBook Pro M1 14-Inch 2021, MacBook Air M2 13.3'' 2022-2018, MacBook Pro M2 13'' 2022-2016, Dell XPS 13, Surface, HP, Acer - Cloudy Marble Design By FINPAC
39 Review
Radar detector Inspector Spirit
39 Review
StarTech.Com HDMI To VGA Cable – 6Ft 2M - 1080P – Active Conversion – HDMI To VGA Adapter Cable For Your VGA Monitor / Display (HD2VGAMM6)
38 Review
Another interesting products
🛩️ Stratux ADS-B Dual Band Receiver: Advanced Aviation Weather and Traffic System with WAAS GPS, AHRS, Battery Pack, Suction Mount, Antennas, SDR
9 Review
🗺️ CARRVAS GPS Navigation System for Car, 2021 MAP 7inch Truck GPS Navigation, Spoken Turn-by-Turn Directions, Speed Warning, USA, Canada, Mexico, Lifetime Maps Update
9 Review
🎧 FARO Aviation Headset Converter: Low to High Impedance Adapter for General Aviation (GA) and Military Headsets
9 Review
🔍 MANN-FILTER W 811/80: The Optimal Oil Filter for Enhanced Engine Performance
11 Review