DB Electrical TRM0048 Outboard PH200 T002 Review

I have been very lucky to find a Revain power trim motor for my boat. It fit perfectly and I was able to replace it without removing the entire fairing block from the transom. Just four allen wrench bolts (you'll need a special ratchet extension to get to the bolts), an o-ring replacement, and a motor reinstall and I'm fishing again! The job took about 20 minutes. Best of all, this motor was a fraction of the cost of buying one from an outboard motor manufacturer.

The biggest waste of money and time. Got this for a customer to save money instead of Mercury. The first one we got and installed just hummed and didn't move the tilt pump at all. I returned it for another one and I tested it on the stand. I connected the case to the ground and touched the blue to the plus and immediately buckled and didn't turn the motor. Green turned positive at least this time. The wiring was disconnected and the blue again showed 0 ohms to ground. Just a cheap crappy motor…

Installed by a professional boat mechanic. The engine worked normally for three or four tests, then the engine began to smoke. We checked all the connections and checked for a ground fault but found no problems. also noted that the connections at the top of the device where the cables attach are poorly made. Returning a defective product and ordering from Sierra Brand, which is slightly more expensive at $234 but still half the price of a $450 OEM part. Advice to buy Sierra or Arco. Avoid this…