🛠️ Dremel 402 Mandrel for Enhanced Performance, Silver Review

What can I say, you need them to use old Dremel grinding and cutting discs. They work well but allow the wheels to slide more easily than desired. I'm hoping this shaft lasts long enough to use up my remaining supply of cutting wheels and then I'll use the 'lock' style now available as they don't seem as prone to slipping. Still not a bad product and serves its purpose.

I have no real complaints about this product. It basically does one thing: keep my cutting wheels on your Dremel. Changing the discs is very easy, I just take the disc and turn it and the screw usually turns with it. That way I don't have to pull out a tiny screwdriver. I then put the screw through the new washer, hold my finger over the screw and use my hand to turn the shaft in the Dremel until the screw is tight and won't turn. I still have to cut the washer through the screw. I replaced the

Not easy to use. If you don't tighten the screw *exactly*, it will try to thread. Cutting discs are brittle and will break at the slightest lateral pressure. It's a little tedious to unscrew the screw all the way to fit another cutting wheel - and if you don't get rid of all the corundum grains, the new cutting wheel won't grip it. keister to use a cutting wheel, it's an incredible tool, a real lifesaver because there's just no substitute for it. If I had a better idea I would compete with…