💡 Dimmable LED Strip Lights 4200K Daylight: Smart Plug Compatible, Wall Dimmer Control, Waterproof IP65 – 16.4ft Under Cabinet, Cove, and Accent Light Review

Finally around 4:00 p.m. I was able to install it as a backlight. 9;41 and note the inactive LED group. The tape didn't stick well. I ordered the clamps and they fit perfectly. Time will tell if the group of LEDs that went out was an accident or not.

It was exactly what I needed and the bad glue that other reviewers have mentioned is accurate. I can live with that since I'm getting into the canal. What I can't stand is that part of the string darkens after a few hours of use. I will look for a higher quality product.

I don't have more than a few parts but they seem to be of fairly good quality and very bright. I think I need to hook up a light switch to reduce the intensity of the light by a few notches. I think I'm very color blind which makes my eyes sensitive to LEDs in general.

Easy to cut and re-solder but you will need to supply your own 2 conductors, 18 ga. strand. I had three sections with cabinets on the sides of the microwave. I had to cut and splice to get around. It would be nice if more end caps and clips were included. You will need one for each end, only two are included. The grip seems good but I still used clamps although there should be more of them.

I bought a roll for the closet lighting, 2 weeks later 2 more rolls, same color temperature 4200. We installed them and after that we noticed a color difference, no just a little difference in hue, a clearly visible difference in color, so we need to repeat this adjustment. Both packages were labeled 4200K. I don't know what to do now. Even if I buy more rolls I don't know what I'll get. Maybe a different color, 3. So this LED might be good for exterior work or small interior work, but…

Easy to cut and rewire, but you'll need your own 18ga 2-wire conductor. strand. I had three sections with cabinets on the sides of the microwave. I had to cut and splice to get around. It would be nice if more end caps and clips were included. You will need one for each end, only two are included. The grip seems good but I still used clamps although there should be more of them.

Forget the glue, otherwise the product will be very good. It is not possible to find additional end caps and clips that fit light strips. The seller should add more end caps, clips and screws as their glue doesn't work that well or sell them as extra packaging. If the seller can solve this small problem, then his product will be rated as excellent. By the way, I'm willing to buy additional end caps, clamps and screws. Thanks very much!

I bought a roll for closet lighting, 2 weeks later 2 more rolls, same color temperature 4200. We installed them and after that we noticed a color difference, not just a small difference in hue, a clearly visible difference in color, so we have to repeat this adjustment. Both packages were labeled 4200K. I don't know what to do now. Even if I buy more rolls I don't know what I'll get. Maybe a different color, 3. So this LED might be good for exterior or small interior work, but definitely not…