8-Pack Tesla Model 3 Model Y Door Seal Kit: GOLOHO Self-Adhesive Rubber Weather-Strip for Noise Reduction Review

It was easy and straightforward to install. I bought this because the road/wind noise was worse on my Tesla than on my BMW 5 Series. That was my only disappointment at Tesla. I appreciate the silence when I get in the car and drive. This simple modification improved silence and isolation. Thats much better! It really helped a lot! Plus, it looks professionally installed. Not cheap and ugly.

This kit fits the Model 3 perfectly. I was pleased with the instructions (albeit sparse) and the labeled bags. There are some very good videos on YouTube showing how to install this kit. Cutouts for gutters should be made during layout and not during installation as the glue is very tacky and alignment is very important. Attempting to cut/cut drainage holes when working with a long strip of rubber is no easy task. The A-pillar is a bear no matter what kit you have, but everything else is basic.

Really good quality and pretty easy to fit apart from the A pillar (hard to reach). It took about an hour. Each seal is individually wrapped and labeled for easier identification and application. It is important to use an adhesion promoter before installing gaskets. Be sure to cut the drain holes to match the drain holes in the doors. The B-pillar must not cover the entire length of the door, it must be cut where the molding ends. Very good soundproofing! Sometimes I wait for my ears to pop…

They were very easy to install and the quality seems pretty good. I think I spent about 5 minutes on each section of the door but I really took my time. There is a very noticeable difference in road noise reduction. I realized just how little noise there was in my car this morning when I noticed the guy in the turning lane next to me roll down his window to ask if he could switch to my lane instead. I didn't realize he was trying to get my attention until I saw him wave. I didn't hear his voice

I was a little skeptical when I first bought it but based on YouTuber reviews I had to try it. You should clean the car first, especially the door jambs and interior paint for the rubber seals to ensure a strong seal. After cleaning, apply the adhesion promoter and simply follow the assembly instructions. Overall, the installation took a few hours over several days. I slowly did this over each door and didn't want to rush into anything because I wanted the aesthetic of it to look like a…

Good: Door seals come in a nice box with components in clearly labeled plastic bags (Left Front Door, Left Rear Door, Right Front Door, Right Rear Door, A Pillar, B Pillar) Install the contents bags. The included instructions are very easy, but you can find a few helpful YouTube videos by searching GOLOHO. The gaskets appear to be of good quality and there are more than enough packages of adhesion promoter to complete the job. cleaning, preparation. and installation took less than 90 minutes…

Wind noise was noticeably reduced after installation, especially at high speeds. The Model 3 is quiet at first, but it definitely made a difference! Installation was fairly easy, but I would recommend being patient and preparing the A-pillar area properly to ensure good traction. On my initial installation, the A-pillar seal came loose from the door (pictured). The second time I had better results. Here's what I did before attaching the gaskets: 1) Wipe down the areas with a clean damp cloth…

I used to fit a universal gasket kit that I bought on ebay. Unfortunately, over time it began to wear out and fell off. I decided to buy this pre cut set from Goloho and I have to say I'm very impressed! All parts are labeled so there's no confusion about what goes where. I was also very impressed with the front door and B-pillar seals. They have already been pre-cut and shaped which is a huge improvement over my regular ones. The supplied adhesive pads were also positive. The fit and finish…