JEYI iBrace-8 Graphics Card Support 💪 Brace with Universal VGA Graphics Card Holder Review

It still doesn't work, so it copes with its task. If I had to move the computer around a lot (like a LAN party or something), I'd be more concerned. A few bucks now will save me from a warped map that people won't be paying for on ebay in a few years when I'm done. with this.

Supporting that particular GPU in both extreme corners was probably the best idea. The second one I just received even had a magnet under the sticky pad which means this company is great because they listen to their customers suggestions! The best GPU support on the market.

My son's computer is based around a Corsair 220T RGB with an Aorus RTX 3060 TI. Probably should have measured before buying. At first I thought there wasn't enough space between the top of the PSU shroud and the GPU to attach the bracket. I thought I should send it back but then it occurred to me what if I took the red lock nut off and just screwed the bracket all the way in. I did this and it was just the height I needed and I slipped it under the GPU and it worked fine. It was difficult to…

I needed a small, unobtrusive mount for my GPU that didn't have all the silliness and over-engineering of all mounts on the market. I have a small ATX case and my GPU is about 2.75 inches from the top of the HDD platform in my case. I currently have a small foam block sitting in the corner of the GPU to support it. When I saw this, I was pleasantly surprised that anyone thought of it. Unfortunately, that's about half an inch longer than my GPU when closed. If they could make the second version…

Needed support for my graphics card that wasn't too aggressive for my system. The mount turned out to be unsuitable for my setup as the bottom fans in my case didn't allow me to install the mount so after a bit of searching I came across this product. This product has proven to be the perfect height without any adjustment and supports a fairly powerful 3080 ti GPU. In my setup you hardly see it. Attached picture, I just had to find the right angle to even see it to take a picture. Bottom Line…

I bought it first because I liked the simple design and no magnet. However, after doing some research on hard drives and magnets, my fears about magnets were allayed. I wish he had a magnet. The top end has a soft rubberized tip and the bottom end is flat and hard with pre-applied glue. Unfortunately, the peelable cover over the adhesive is very slippery and attempting to use it without removing it will most likely cause the brace to slip. I would prefer a magnet because it leaves no trace and…