Header banner
Revain logoHome Page
πŸ”© spetool carbide aluminum flutes for non-ferrous materials logo

πŸ”© SpeTool Carbide Aluminum Flutes for Non-Ferrous Materials Review

3

Β·

Poor

Revainrating 2.5 out of 5Β Β 
RatingΒ 
2.3
πŸͺš Router Bits, πŸ”ͺ Cutting Tools

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ”© SpeTool Carbide Aluminum Flutes for Non-Ferrous Materials
img 2 attached to πŸ”© SpeTool Carbide Aluminum Flutes for Non-Ferrous Materials
img 3 attached to πŸ”© SpeTool Carbide Aluminum Flutes for Non-Ferrous Materials
img 4 attached to πŸ”© SpeTool Carbide Aluminum Flutes for Non-Ferrous Materials

Description of πŸ”© SpeTool Carbide Aluminum Flutes for Non-Ferrous Materials

Solid Carbide Spiral Router Bit with 1/4 inch Shank and 1/4 inch Cutting Diameter, 1-1/2 inch Cutting Length, 3-1/2 inch for Total Length. The Route Bits With Flat Top, 3-Flute, Upcut For Easy Chip Removal And Perfect Surface Finish. Clockwise Motion for Machining. For Aluminum 6061,7075 etc. Non-ferrous Metal, Plywood, OAK, MDF, and Any Hardwood Working and Long service life for sharp. The Carbide EndMill Suit for CNC Router and Makita, Bosch, and Any Brand Plunge Router with 1/4" Collet. End Mill Bits are Suitable for Side Milling, End Milling, Finish Machining, etc.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    2

Type of review

Revainrating 1 out of 5

Product is scrap and broke in less than 30 seconds

This end mill is scrap and cannot be manufactured as it is supposed to be. Broke in less than 30 seconds of use. I want a refund and I want the manufacturer to contact me immediately.

Pros
  • Certified
Cons
  • New Competitors Arrived

Revainrating 1 out of 5

Special Chinese Carbide

Made in China so you know what to expect. Worked great for the first 15 minutes. But it went downhill from there, it's not a carbide drill as claimed as the tips broke off when cutting the aluminium. This might work great for wood and plastic, but if you're using this for AL, keep looking. Pure garbage!

Pros
  • Easy to read control panel
Cons
  • Disappears

Revainrating 5 out of 5

This is a 1/4 inch tool, know your limits and make chips!

No problem with this tool o read some negative reviews but it's a 1/4" tool and you can't slide it especially when plunging or side milling aluminum as it can jam without coolant (use Some coolant or even WD-40 helps!) Overall I'm happy with it, it did 30 holes at 23Β° as fast as I could turn my old Bridgeport

Pros
  • Everything is fine!
Cons
  • Expensive