🕶️ BlazerBuck Oakley Transistor Sunglass Replacement - Men's Accessories Review

Worked great on my OX5113-0251 frames. For a fairly painless installation that probably only took 5 minutes per temple, recommend the following: 1. Soak the cuff in boiling water for a few minutes.2. Prepare the shackle by removing the old bushing if it is still intact and cleaning the area underneath. I just used windex and soft cloth.3. Using something like a toothpick, smear the ridge at the end of the temple with some liquid soap (I used Dawn) where the sleeve will slide. Also, I smeared…

Replacement parts for my OX3102 Oakley are being discontinued. It was a shot in the dark, and it worked. Difficult to put on, but if you want a tight fit, find out. He heated the awl with hot water, lathered it and inserted it halfway into the tube to stretch the entry point, heated the tubes with hot water. Soaped glasses and pipe. I stored the test tubes and jars with a rag because they are very slippery. A little fishing patience and they are finally in place. Take a deep breath and keep…

I ordered these for a pair of Oakley Casing frames and they were fitted incorrectly. However, they match perfectly with another Oakley set I have.

They match my Oakley glasses perfectly. I put them on without using soap or putting them in boiling water so as not to damage them or leave marks between the frame metal and the rubber. They were quite tight as I expected but I ended up putting them on. I would check the model number before ordering to make sure it is for your glasses. My frame says Spoke 0.5 on one side and OX3144 on the other.

Exactly as advertised. I was going to order black but wasn't paying attention and ordered gray instead. Still works and they have come out perfect. I read a few reviews and the advice on usage was spot on. Apply a little dish soap to the tip of the jar and soak the sock in boiling water for a few minutes. At first one slipped right on top of the other, it took a little more persuasion but he prevailed in the end.

Everything looked good, fitted the glasses well, was comfortable for a while but after a month or so there was irritation where they came in contact with my ears/hair. Had to remove it and it still broke a bit but got better after a month.