🦅 High-Quality Eagle B16 114 4 Inch Galvanized Straight - Durability & Performance at its Best Review

I use these nails in my porter/cable nailer and they work very well with no faults. I would recommend these mounts to my friends.

In my busy season I hit about 3000 nails a week with my Ridgid nail gun and they worked well, just the usual, rare occasional failures. Definitely good value for money.

They are much stronger than my regular 18 gauge nails and as each set is more compact than regular nails my Paslode nailer can handle many single loads of nails.

I have used them for converging baseboards etc. Working alone, I had to align and support one end while an extra person holds the other end. They worked great.

Loaded my smaller end nail gun with it and found myself firing blanks after the first one - excuse the pun. After some research I found that the heads on them are almost imperceptibly larger than the Paslode brand heads I usually use and this causes them to not feed properly into the nailer. See photo of potatoes - this is on the left, paslode on the right. You can see that the ones on the left are slightly larger/thicker than the ones on the right. My larger nailer will shoot them and I spent…

Along with other brands I have been using B&C nails over many years in all my different air nailers never had a problem with them. These 1-1/4" nails work great in my 16 gauge PC nailer. No issues with nail strips getting caught or snagging in the nail chute. Types of exterior work. I usually use galvanized nails these days for interior trim and all and since the price difference isn't really that big I don't even bother to have bright nails for my pneumatic nailers I think these are very good…

I used them to attach baseboards etc. I work alone and had to line everything up and hold one end while an extra person holds the other end. They worked great.

Loaded this into my smaller finishing nailer and found I fired after the first space - pardon the pun. After some research I found that the heads on them are almost imperceptibly larger than the Paslode heads I usually use and this causes them not to feed properly into the nailer. See photo of potatoes - this is on the left, paslode on the right. You can see that the ones on the left are slightly larger/thicker than the ones on the right. My larger nailer will shoot them and I wasted quite a…

In addition to other brands, I have been using B&C nails in all my various pneumatic nailers for years and have never had any problems with them. These 1-1/4" nails work great in my 16 gauge PC nailer. No issues with nail strips getting caught or snagging in the nail chute. Types of exterior work. I usually use galvanized nails these days for interior trim and everything and since the price difference isn't really that big I don't even bother to have flashy nails for my air nailers I think…