Header banner
Revain logoHome Page
enhanced performance intake manifold - edelbrock 2716 eps logo

Enhanced Performance Intake Manifold - Edelbrock 2716 EPS Review

3

·

Poor

Revainrating 2.5 out of 5  
Rating 
2.5
🚀 Engines & Engine Parts, 🏎️ Performance Car Parts & Accessories

View on AmazonView on ЯM

Media

(4)
img 1 attached to Enhanced Performance Intake Manifold - Edelbrock 2716 EPS
img 2 attached to Enhanced Performance Intake Manifold - Edelbrock 2716 EPS
img 3 attached to Enhanced Performance Intake Manifold - Edelbrock 2716 EPS
img 4 attached to Enhanced Performance Intake Manifold - Edelbrock 2716 EPS

Description of Enhanced Performance Intake Manifold - Edelbrock 2716 EPS

Idle-5500 RPM Range. Dual Plane Type-4150 Style Flange. 2. 5 in. Front Height, 3. 2 in. Center Height, 3. 9 in. Rear Height. Satin Finish. Non-EGR. Fit type: Vehicle Specific.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    0
  • 2
    1
  • 1
    1

Type of review

Revainrating 2 out of 5

Waste of Money best in my review

After trying this product, I found it to be completely useless. It did not improve the performance of my automotive engine whatsoever. In fact, it caused more problems than it solved. The only positive thing I can say is that it looks nice, but that's not enough to justify the cost. Save your money and invest in a better quality product.

Pros
  • Looks nice
Cons
  • Did not improve engine performance

Revainrating 5 out of 5

Performance Replacement Parts

This intake manifold was purchased in place of the Edelbrock air gap for the Vortec heads because Edelbrock did not make the Vortec air gap when I was looking for the intake manifold. I was very happy with it. Even with a higher 10.5:1 compression ratio and 34 degree valve timing, this air intake is a great design and delivers more power without detonation in my application. I use a 180 degree thermostat and a 3/4" aluminum dual row radiator with a 50/50 mix and Hyper Lube Supercoolant…

Pros
  • Intake Manifold
Cons
  • Some Cons

Revainrating 1 out of 5

Make sure you actually have Vortec Heads.

Can't really blame the manifold - it's a quality part. But this is not suitable for my application. I thought my heads were "Vortec" but they were actually "Swirl" making "Vortex" - cast iron heads from 1987 to 1990 or so - basically "TBI heads" aren't Vortec heads! True Vortec heads were only available for a few years before they switched to LT1 engines. It was my fault, not this product's fault, but as I found out, this error is common. So be sure you have Vortec heads and they will work just

Pros
  • Automotive
Cons
  • I won't say anything