💧 Moisture Compression of EVacuum Printer Filament Review

This kit works great. I really only needed a pump and pouch so can't speak to wet strips. In the last 2 years I've used maybe 5 full coils out of the 30+ I've accumulated. As I have a lot of used coils I thought it was time to store them better as I wanted to avoid possible dehydration. I've had PLA in my pocket for several months and it hasn't lost its seal. I've also reused the black eSun PLA roll case a few times. Even some new rolls lose their tightness in less than a month. With that in…

The vacuum function is very difficult to use, even when placed over a hole it does not always create a vacuum. And when that happens, each little pump sucks in so little air that you have to do it a million times. But to make matters worse, I vacuum sealed all my coils and made sure the zipper was fully closed. After 30 minutes, the bag will look like it was never vacuumed. He couldn't stand this vacuum. I am very disappointed and recommend you to buy something else. UPDATE: Two weeks later…

ORIGINAL REVIEW (see update below) ---------------------- ------ --- ---- If the pumps in the two sets I ordered hadn't cracked I would give this one 4 stars. Pros: *Large bags fit easily. My thread tangles.* Bags are well constructed, strong and easy to close.* Works with the extra suction port on my FoodSaver vacuum sealer.* Convenient moisture indicator and desiccant included. Cons* The acrylic nozzle at the top of the pump was cracked, preventing vacuum generation. * The above cracks…